Crest Model F300 Superheated Ultrasonic Parts Washer

Loeb # 74172 Model F300
OEM Crest Ultrasonics Corp
Year Serial
Electrical Location Illinois
Condition As is Size 0.00
Lease for only 4,374.78 / mo. Rent for only N/A
Have one of these to sell? ITEM SOLD: Need One Of These?
Crest Model F300 Superheated Ultrasonic Parts Washer. Including: 2nd Rinse Tank with 40 KHz Ultrasonics, Superheat Drying Set Down, Dual Spray Header, Parallel Basket Automation with Upper Enclosure, S/S Baskets, Solvent Transfer Pump Package, Molecular Sieve Pack, Sub Micron Series Filtration. General system features: Offset boil sump, Dual ultrasonic immersion sumps, 304 stainless steel passivated process tanks, 304 stainless steel support frame and counter top, 304 stainless steel, lift-off access panels, 300 series stainless steel plumbing with compression and/or welded fittings where appropriate, NEMA 1 electrical enclosure with single point electrical connection, Front mounted, recessed operator interface panel, Maximum Basket Size: 16 inches x 10 inches x 10 inches, Vapor Zone Height: 12 inches, Total Solvent Volume: 50 gallons, Water cooled dual on board refrigeration systems – Requires external cooling water supply of 6 GPM at 75º F, Boil Sump Features: On-board, indirect hot water-heating system, Temperature control probe with over temp protection and solvent change out alarm feature, Low liquid level safety, Clean out door, Wash Tank Features: 5 GPM recirculation/filtration system including: 1000W of 40, 58, 132, or 192 kHz ultrasonics, Pump protection strainer, Centrifugal pump featuring a stainless steel pump head, teflon encapsulated, Viton seals, gaskets, and O-rings, and a TEFC motor. Stainless steel filter housing, 10 micron filter, Pressure gauges to monitor filter pressure drop, Manual flow control valve, Manual isolation valves. Rinse Tank Features: 5 GPM recirculation/filtration system including: 1000W of 40, 58, 132, or 192 kHz ultrasonics, Pump protection strainer. Centrifugal pump featuring a stainless steel pump head, teflon encapsulated Viton seals, gaskets, and O-rings, and a TEFC motor, Stainless steel filter housing, 5 micron filter, Pressure gauges to monitor filter pressure drop, Manual flow control valve, Manual isolation valves, Superheated Vapor Zone: High surface area tube and fin heat exchange coils, Capable of up to 30º F above the boiling point of the solvent, Provides quick and complete drying of parts to reduce dragout, Freeboard Zone: 120% freeboard ratio to minimize solvent loss, Independent primary and secondary condenser units with direct expansion valves, Stainless steel primary cooling coil, Stainless steel freeboard cooling coil, Defrost cycle for freeboard cooling coil, Continuous cooling will be provided by the primary coil during the secondary defrost cycle, Independent water separation housings for the main and secondary condenser coils, The water is removed manually from the system via ball valves., High vapor temperature sensor Manual sliding downtime cover
http://www.youtube.com/watch?v=xGwS6KbE_60

Have Inventory to Purchase or Sell?

Looking to purchase equipment? Have one of these to sell?

Click Here